Program A Sensor / Auto Learn Mode IQ2

There will be videos attatched for most sensors below instructions

1) Tap on the grey bar at the top middle of the screen

2) Tap Settings

3) Tap Advanced Settings

4) Enter either, Installer(Default 1111), Dealer (Default 2222)

5) Tap Installation

6) Tap Devices

7) Tap Security Sensors

8) Select Either "Add Sensor" or "Auto Learn Sensor"

Auto Learn Sensor:

1) Open the cover tamper for the device or press tamper button inside the sensor when needed

2) Sensor will be displayed on screen, confirm information and continue.

Add Sensor:

1) Fill out the information needed for the sensor that is currently being programmed in

Note: GeoArm recommends using "Auto Learn Sensor" as it is much friendlier to DIY installers

Enroll PG9914 Motion Detector: 

https://www.youtube.com/watch?v=1rzgLozbTek

Enroll PG9945 Contact:

https://www.youtube.com/watch?v=lvunefTDk1Q

Enroll PG9939 Key Fob: 

https://www.youtube.com/watch?v=WF-86cNkS3I

Enroll Power G Sensor:

https://www.youtube.com/watch?v=3yZSuLTg_D4

Enroll IQ Light Bulb: 

https://www.youtube.com/watch?v=5qXwC06zesc

Enroll QS5110-840 Smoke Detector: 

https://www.youtube.com/watch?v=AEZ-FM-DsK0

Enroll IQ Carbon:

https://www.youtube.com/watch?v=omNLr-3p-9M