Event Log 80 Percent Full Report Code

1) Enter Installer Code on the panel while disarmed (Default 4112) + 800

2) You Will now see 20 INSTALLER CODE if that was the correct installer code.

3) Press *89

If an Event Logging selection is made in field ✻90, a message can be sent to the central

station receiver when the log is 80% full. If the log becomes full, a new message will

overwrite the oldest message in the log.

Note: All control and readout from the log, aside from the selection made by the installer in

field ✻90, is accomplished via the downloader. 

4) Press *99 After the screen updates to the next field to exit programming

Note: GeoArm can change the installer code upon activation

Follow Install manual for more information: 

https://turbifycdn.com/ty/cdn/yhst-51756635596032/l3000-honeywell-lynx-plus-wireless-control-panel-installation-and-setup-guide.pdf