Alarm Restore Report Code

1 min. readlast update: 10.17.2023

1) Enter Installer Code on the panel while disarmed (Default 4112) + 800

2) You Will now see 20 INSTALLER CODE if that was the correct installer code.

3) Press *70

1st digit is sent when the zone that caused an alarm is restored to its non-faulted

condition. If expanded or 4+2 reporting is selected, 2nd digit is automatically sent as

the 2nd digit of the zone alarm report code programmed in field ✻56.

4) Press *99 After the screen updates to the next field to exit programming

Note: GeoArm can change the installer code upon activation

Follow Install manual for more information: 

https://turbifycdn.com/ty/cdn/yhst-51756635596032/l3000-honeywell-lynx-plus-wireless-control-panel-installation-and-setup-guide.pdf

Was this article helpful?